SMR Gearbox Set up

SMR Gearbox Set up
Satisfactory effectiveness depends on good installation. lubrication and upkeep. as a result it is important the guidelines within the set up and servicing leaflet. supplied with each gearbox. are followed meticulously. some of the critical elements of belt and torque-arm installation are listed below.
1. Install pulley on gearbox input shaft as shut towards the reducer probable, and mount reducer on driven shaft as near to bearing as useful. failure to complete this will likely cause extra loads within the input shaft bearings and output bearings and could induce their premature failure.
2. Install motor and wedge belt drive with the belt pull at roughly 90° towards the center line in between driven and input shafts. this can allow tensioning of the wedge belt drive using the torque arm which ought to preferably be in stress. if output hub runs anti-clockwise. torque arm need to be positioned the correct.
3. lnstall torque-arm fulcrum on a rigid support in order that the torque-arm might be at around right angles to the center line through the driven shaft and the torque arm case bolt. ensure that there may be sufficient consider up during the turnbuckle for belt stress adjustment.
Maintain close.
Bell drive may be found in any hassle-free postion. should the torque arm is usually to be employed to tighten the belts, the drive should be at about tight angle to your line in between the input and output shafts.
Bell drive may be found towards the proper if desired.
If output hub rotates clock-wise. position belt drive and torque arm in opposite course to that proven inside the illustration.
Torque arm and belt consider up.
Torque arm can be mounted towards the suitable if preferred.


flexible disc coupling

As one of leading flexible disc coupling manufacturers, suppliers and exporters of mechanical products, We offer flexible disc coupling and many other products.

Please contact us for details.


Manufacturer supplier exporter of flexible disc coupling.

Recent Posts