Materials Managing Electrical power UNIT 1
This energy unit is built for that fork lift industry, consisting of hugely efficient gear pump, DC motor, guide raise and reduced valve, tank, ect. The up and down motion are controlled by the lever of the guide release valve, that’s outfitted with an electrical switch to activate the motor. The lowing velocity is controlled by the stress compensated movement manage valve.
one. The duty of this energy unit is S3, i.e. thirty seconds on and 270 senconds off.
2. Clean the many hydraulic elements concerned before set up of the electrical power unit.
three. Viscosity of your hydraulic oil shoud be 15~46 cst, which really should also be clean and cost-free of impurities, N46 hydraulic oil is encouraged .
4. Oil shifting is needed right after the initial a hundred operation hours, afterwards as soon as every single 3000 hours.
five. The energy unit shown is built to be mounted horizontally.
Material Dealing with Energy UNIT 2
This electrical power unit capabilities power up gravity down circuit. Activate the commence solenoid to start out the motor to lift the machine. The lowing movement is activated from the solenoid valve with the decreasing speed managed by the pressure compensated flow handle valve. Products of this series might be widely utilized in the sector of logistic units for instance fork lift, mini lift table, etc.
one. The duty of this energy unit is S3,i.e.,thirty seconds on and 270 senconds off.
2. Clean all the hydraulic elements concerned ahead of mounting the power unit.
3. Viscosity with the hydraulic oil shoud be 15~46 cst,which should really also be clean and absolutely free of impurities, N46 hydraulic oil is advised .
4. Oil altering is required right after the initial 100 operation hours,afterwards after every 3000 hours.
5. The power unit needs to be mounted horizontally.