DUMP TRAILER Energy UNIT- SINGLE ACTING
This energy unit includes a electrical power up gravity down circuit. Start off the motor to extend the cylinder and activate the solenoid valve to retract the circuit. Guide override to solenoid valve may be presented if expected. Also a stress compen sated movement management might be extra to the circuit to manage the descent velocity on the cylinder.
Remark: Please seek the advice of our income engineer for the distinct pump displacement, motor electrical power or tank capacity.
1. This energy unit is of S3 duty cycle, i.e., non-continuous operation, thirty seconds on and 270 seconds off.
two. Clean every one of the hydraulic elements concerned in advance of set up of the power unit.
three. Viscosity from the hydraulic oil shoud be 15~46 cst,which must also be clean and totally free of impurities.N46 hydraulic oil is advised.
four. The electrical power unit ought to be mounted horizontally.
5. Check the oil level while in the tank soon after the initial operating with the power unit.
six. Oil modifying is required immediately after the original 100 operation hrs, afterwards once every single 3000 hrs.
DUMP TRAILER Power UNIT-DOUBLE ACTING
This electrical power unit features a energy up electrical power down circuit with load holding on both A & B ports. A strain compensatred flow manage could be additional to circuit to regulate the decent speed from the cylinder.
one. This power unit is of S3 duty cycle, i.e., non-continuous operation, 30 seconds on and 270 seconds off.
two. Clean all of the hydraulic elements concerned prior to set up of the power unit.
three. Viscosity of your hydraulic oil shoud be 15~46 cst, which must also be clean and totally free of impurities. N46 hydraulic oil is advisable.
4. The power unit must be mounted horizontally.
five. Check the oil level inside the tank following the initial working of your power unit.
six. Oil changing is needed after the preliminary a hundred operation hours, afterwards as soon as each 3000 hrs.