Around the world regular chains complying with JIS and ANSI

The 14 sizes of standard roller chains are available ranging from 25 to 240 together with those in conformity with ANSI (American National Common Institute), and ISO (International Organization for Pipeline centrifugal pump&slow rotary velocity centrifugal pump Standardization).
The chains not merely meet the demands to the minimal tensile power prescribed by ANSI and ISO, but they also give the prime class excellent during the planet which includes a large fatigue strength
Appropriate employs
?Basic use for driving and lifting tools.
Examples
?Driving transfer units and other gear. For multilevel parking.
Choice of chains
For choice of a chain, see the tables of “Max. Horsepower Ratings” for normal roller chains and “Designing of Chain Transmission”. However, only for any special situation of very low velocity and less shock, “Low-speed selection” technique may also be referred to.
Regular roller chains as much as 5 strands can be found. The common method for connecting pins and plates is rivet kind (RP).
The cotter variety (CP) is available for regular chains and HK chains of 80 or bigger.
Sprockets
The typical roller chains can be engaged with normal sprockets of the corresponding nominal numbers. For sprockets, refer to your table of “Dimensions” for each dimension of chain.
Connecting back links and offset hyperlinks
For connecting back links and offset hyperlinks, refer to the table of “Dimensions” for each dimension of chain.
The connecting links are usually R or C connecting links during which the pins are clearance-fitted with all the connecting plate. Considering the fact that clearance-fitted hyperlinks are inferior to your base chain in Max. allowable stress as while in the situation of one-pitch offset links (OJ), “Low-speed selection” cannot be referred to. Because the Max. kilowatt ratings are made the decision thinking of the strength of connecting links and OJ, the clearance-fitted connecting backlinks and OJ is often employed if your chains are picked according to your “General selection”. When a larger Max. allowable stress is needed to the connecting link, use the interference-fitted connecting hyperlink (H connecting website link) of a HI-PWR-S chain, and within the situation of offset backlinks, use 2POJ.