Energy UNITS FOR LIFT TABLE one
Basic Description
This electrical power unit is made solely for the compact lift table,Consisting of substantial strain gear pump, AC motor, multi-functional manifold, valves, tank, etc. This power unit is broadly employed while in the market of logistic units for instance minifork lift, scissors lift and ariel working platforms. The lower-ing movement is controlled from the solenoid valve together with the velocity controlled from the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE 2
Basic Description
This energy unit is created exclusively for the medium lift table, Consisting of extremely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering movement is actived through the solenoid valve as well as velocity managed through the adjustable needle valve. Once the lift rises to a high positoin, but the power supply is lower, the decreasing motion is controlled by the manual override perform.
Power UNITS FOR LIFT TABLE 3
Common Description
This energy unit is designed exclusively for the substantial lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived by the solenoid valve as well as speed managed by a pressure compensated movement control valve.
Power UNITS FOR LIFT TABLE 4
Common Description
This energy unit is built exclusively to the massive lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived from the solenoid valve plus the pace managed by the adjustable needle valve. When the lift rises to a large positoin, but the energy supply is lower, the decreasing motion is managed from the guide override perform.
Particular Notes
one. This power unit is of S3 duty cycle, which can only function intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean all the hydraulic elements concerned just before set up of the energy unit.
three. Viscosity from the oil shoud be 15~46 cst,which should also be clean and absolutely free of impurities.N46 hydraulic oil is advised.
4. Oil transforming is required right after the first one hundred operation hours,afterwards when every 3000 hours.
five. The electrical power unit shown is created to be mounted vertically.